1192AGBlogDETAIL

Best Practices for Avoiding Electrical Risks

11/08/2022 Written by: Gina Ekstam

Electrical risks are one of the most overlooked hazards in agriculture. According to the National Ag Safety Database (NASD), thousands of workers are shocked and burned due to accidental contact with electricity each year, and an estimated $1.2 billion in property damage occurs because of faulty electrical usage.

 

Accidents happen for a variety of reasons. One of the biggest dangers is overhead power lines. Workers using portable grain augers, large wagons, combines, fold-up cultivators, and other tall equipment should know where power lines are located as well as the clearance needed for equipment that must travel underneath the lines. Maintaining a minimum 10-foot clearance between the power line and the top of equipment traveling under it is a good rule of thumb. It’s also important to keep in mind that some equipment during transport may be taller when in use.  

 

Electrical current from high voltage lines can flow through a vehicle and energize the ground up to 100 feet away. If a vehicle comes in contact with a power line, workers should stay in the vehicle unless there is a fire, in which case they should jump as far away as possible. Immediately contact the utility company to have the power shut off. Further, the NASD cautions:

  • No part of the worker’s body should touch the equipment and the ground at the same time.
  • Both feet should always remain in contact with the ground. Shuffle slowly away from the equipment until at least 100 feet away.
  • Once away from the vehicle, please don’t touch it or try and get back on because many electrocutions occur when someone dismounts, then gets back on the vehicle, assuming there is no problem.

 

Electrical hazards can also result from the degradation of electrical wiring due to rodents, normal wear, corrosion, or improper wiring. Regularly checking electrical panels, lighting, equipment, wiring connections, and outlets on buildings and equipment is an important step towards protecting workers and property. And because water is essential to any agribusiness, ensure all wiring is protected against contact with water.

 

If you have livestock, vapors from animal waste in confinement housing can corrode electrical components. High humidity in milking facilities can deteriorate conventional metal electrical boxes.

 

To minimize electrical risks:

  • Determine risks for potential electrical shock and restrict access to those areas.
  • Locate all buried lines and keep the information available for reference before any digging operations.
  • Provide adequate training for all workers. Train them in rescue and emergency procedures so everyone in your operation knows what to do in an electrical emergency. Train seasonal workers about dangers and give additional reminders.
  • Apply decals to all equipment that may pose electrical hazards and explain decals to workers who work with the equipment.
  • Inspect equipment for transport height and determine clearance with any power lines under which the equipment must pass.
  • Use underground feeder (UF) electric cables.
  • Make sure all control boxes, light fixtures, switches, and receptacles are made of corrosion-resistant materials.
  • Install watertight covers on receptacles and switches and over light bulbs.
  • Locate the distribution panel away from severe environments. If a clean, dry area such as an office is unavailable, mount the distribution panel in the driest place possible. If outside, locate it under an awning.
  • Run conductors through horizontal conduit and seal the conduit ends so moisture cannot enter the distribution panel. When conductors run from a warm, moist environment to a cold location, condensation can form and enter the distribution panel.
  • Review the possibility of underground utility supplies for new or replacement power lines.
  • If you have a standby power system, review its location, operation, and importance with all workers.

 

Avoid tragic accidents by taking the time to monitor work that takes place around power lines and electrical equipment. Contact AssuredPartners Agribusiness resources to help your operation foster a culture of safety.

Agribusiness Worker Demands
H-2A Worker Demands Continue to Increase
Agribusiness04/15/2024

Even before the longstanding labor market crunch, farms had difficulty recruiting domestic workers for farm work. This resulted in farms increasingly turning to the H-2A visa program to get...

Grain Bin Safety
Grain Bin Safety Week: 10 Years of Saving Lives
Agribusiness03/22/2024

Grain Bin Safety Week, sponsored by Nationwide Agribusiness and supported by AssuredPartners Agribusiness and many other industry partners nationwide, occurs each year on the third full week of...

Man crouched down inspecting plants in greenhouse
5 Trends to Watch in Agribusiness Technology
Agribusiness02/16/2024

Agriculture has undergone significant technological advancements in recent years, and the trend is set to continue as the industry turns to technology to optimize processes and reduce costs. In this...